Innovate LC-1 Standalone Wideband Controller
The LC-1 includes the sensor, cable, deep bung with plug, wiring for ground/calibration and logworks software to record through a serial port.
You can check out the installation directions here.
The LC-1 Lambda cable is a complete wideband controller built in to a sealed cable. It features …
$179.99
36# L67 Injectors
Set of 6 used Bosch injectors that have been cleaned and tested for a proper spray pattern. Commonly called 36# injectors, these are measured at 352cc/min, or 33.5 # at 3 bar. These use the same connector as 1999 and older 60V6 motors. 2000+ multec 2 will need to change the connect…
$129.99
Cometic BMW M20 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .070 thickness is the std thickness. Gaskets listed as in stock are .070" when we have them. Otherwise please allow up to 2 weeks for the gasket to ship.
$199.99
Cometic BMW M50B20 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .070 thickness is the std thickness. Please allow up to 2 weeks for these to ship as we do not currently stock them.
$204.99
Cometic BMW M50B25 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .070 thickness is the std thickness. Please allow up to 2 weeks for these to ship as we do not currently stock them.
$204.99
Cometic BMW M52B28 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .070 thickness is the std thickness. Please allow up to 2 weeks for these to ship as we do not currently stock them.
$204.99
Cometic BMW M54B22 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .030 thickness is the std thickness. Please allow up to 2 weeks for these to ship as we do not currently stock them.
$159.99
Cometic BMW M54B25 MLS Head Gasket
Available in any thickness that Cometic has to offer, though .030 thickness is the std thickness. Please allow up to 2 weeks for these to ship as we do not currently stock them.
$159.99
ARP Head Studs for BMW M50
Undercut ARP Head Studs for the BMW M50 motor. These are not stocked currently and take approx 2 weeks to get. We will be stocking these again soon.